The Best Way to Paste wallpaper in the corners: instructions, gluing outer, inner corner, docking

Step by step directions for gluing inner corners

After finishing, the principal problem can be irregular walls as well as the consequent folds on the wallpaper. It’s also necessary to take into consideration that if the walls are twisted , the joints of background canvases could invisibly.

After gluing the last one in the front of the inner corner of the fabric must measure the remaining distance. It is measured from the border of the pasted cloth to the adjoining wall, so the resulting figure is inserted 10-15 millimeters. When the walls are extremely curved, the additional figure may be more.

Cut a strip equivalent to the resultant figure, taking into account the allowance. The surfaces have been treated with glue. Depending on the form of coating it might be just the wall or both surfaces.

The strip is then glued independently with the cut side into the wallsocket. The background should go on the opposite plane.

If the glued wallpaper is sterile, then you will need to make a few tiny cuts perpendicular to the folds.

Level or incline on the adjoining wall is a vertical lineup. The distance in the corner is equivalent to the width of the former cut strip, never such as additions.

The surfaces have been smeared with glue, and then the coat is glued into the wall with the flat side into the line. The cut goes onto the adjacent wall.

The best way to glue the outer corner (outer corner)?

Protruding corner should be glued by analogy using an inner, however there are little gaps, which also need to be taken into account when working.

Measured the distance remaining from the glued background into the adjacent wall. Add 20-25 millimeters to the obtained figure.

A section is cut away, taking into account the added 20-25 millimeters.

Prior to gluing, the surfaces are treated with adhesive.

The edge must be glued to the background fixed onto the walls, the own cut side”extends” to the adjacent plane. If needed, small cuts are made in the area of going to the other background, smoothed and pressed to the wall.

Draw a vertical strip on the adjoining wall at a distance of just glued cut strip plus 6-10 millimeters.

After applying the glue, the strip is then put on the wall with its flat side to the marked line, moving over the edge of this glued strip.

The joints are smeared with glue and ironed with a rollercoaster. Following that, the upper layer is trimmed across the ruler and the 2 layers gidpola.ru are joined together.